Model:  Pantah_sidestand
Part Number:  Pantah_sidestand

Pantah Side Stand Conversion and Cagiva Alazzurra 650. Fabricated and made in the UK with undercoat primer.

1. Please note that the stand has been designed to fit with the OE ‘Conti’ silencers

1. This stand has been developed to hold the machine at a safe angle, although very strong, it is not advisable to attempt to kickstart the machine when only on sidestand.
2. The stand reduces left hand side ground clearance, by a very small amount. For ordinary road riding this should not be a problem. For trackday use, you may wish to remove the leg.

2. Tools for fitment:

13mm ring spanner, 17mm socket, 17mm ring spanner.Some form of car jack device and or an assistant able to hold the machine off its centrestand.

3. Start by placing the machine on a level surface, and then onto the centrestand.
4. Remove bottom rear main engine to frame bolt, and fit new bolt supplied, making sure to have the thread on sidestand side.
5. Place a suitable Jack ( or pieces of wood etc) under bike, and gently raise so as to take up the load on the left hand side of Centrestand leg.  (alternative is to roll bike off centrestand and have assistant hold bike).
6. Remove Left hand centrestand bolt and replace with new one provided.
7. Place new side stand onto frame and fit washers and nuts and tighten, remove jack or supports.
8. Check and tighten all nuts again and ALWAYS remember to fold stand up before riding off!

Our delivery costs are based on weight and, therefore, will be calculated in the basket, once you've selected your delivery destination country. However, we have added a guide on our Delivery Page to help you.

Our Returns information can be found here.